Owner manual

10Base-T to 10Base-2 Converter
10Base-2 Connection
To connect to an Ethernet using 10Base-2 cable, do
the following:
1. Attach the supplied BNC T-connector to the
Converter’s BNC connector.
2. Connect one end of a Thinnet (10Base-2) coaxial
cable to the BNC T-connector attached to your
Converter.
3. Connect the other end of the coaxial cable to the
BNC T- connector attached to the Ethernet device.
Note: If either your converter or the Ethernet device is
an end node, attach a BNC terminator to the open
connector on the BNC T-connector.
-11-