Owner manual

Commands for Host-Processed Modems Reference Manual
100498E Conexant 3-49
N - Automode Enable
This command is included for compatibility only and has no effect other than returning a
result code. The only valid values are 0-1.
Syntax
N[<mode>]
Defined Values
<mode > Decimal number corresponding to the selected value: 0-1.
Result Codes
OK <mode> = 0 to 1.
ERROR Otherwise.
3.2.7 V.8/V.8bis Commands
+A8E - V.8 and V.8bis Operation Controls
This command is defined for two conditions: as a parameter while the modem is on-hook,
and as an action command while the modem is off-hook. If enabled, V.8 negotiation does not
preclude simultaneous implementation of other negotiation means (e.g., V.8bis, V.18, V.32bis
Annex A).
This command is a compound parameter if issued while the modem is on-hook, used to
precondition V.8 and V.8bis originating and answering operation. It is issued by the DTE
before the Dial (D) or Answer (A) command, regardless of the state of the +FCLASS
parameter.
This command is an action command if issued while the modem is off-hook, to (re)start V.8
or V.8bis negotiation. For example, if initial V.8 negotiation failed, but subsequent T.30
negotiation indicated V.8 capability, this command may be used to initiate V.8 negotiation.
Syntax
+A8E=<v8o>,<v8a>,<v8cf>[,<v8b>][,<cfrange>][,<protrange>]
Defined Values
<v8o> Decimal number which enables/disables issuance of +A8x
indications during modem-controlled V.8 origination negotiation
1 Enable DCE-controlled V.8 origination negotiation
without +A8x indications. (Default.)
6 Enable DCE-controlled V.8 origination negotiation
with +A8x indications.
<v8a>= Decimal number which enables/disables issuance of +A8x
indications during modem-controlled V.8 answer negotiation.
1 Enable DCE-controlled V.8 answer negotiation
without +A8x indications. (Default.)
5 Enable DCE-controlled V.8 answer negotiation with
+A8x indications.