Quick Start Guide

1.Network Setting
The default IP of all cameras is 192.168.1.168. The IPv4
address of the computer must be in the same network
segment as the IP address of the IP camera. To enable the
camera to access the network smoothly, plan the available IP
network segments based on the actual network environment.
(1) Add the same network segment IP as 192.168.1.168
(camera factory default IP) in the computer, such as
192.168.1.165.
Step 1: Click [ ]Start → [Control Panel] → [Network and
Sharing Center] → [Local Network] → [Properties] → [Internet
Protocol Version 4 (TCP/IPv4)] → [Advanced] to enter the
advanced TCP/IP setting interface.
Step 2: Click [Add] in the IP address (R) position, enter the IP
address as 192.168.1.165 and the subnet mask
255.255.255.0, and click [Add] → [OK] → [OK] → [OK].
(2) Connect camera and PC by network cable in the same LAN,
power on. Connecting as following (PoE switch, camera, PC
connection photo).
Prepare the network configuration:
Steps to add an IP address to the Windows system: