Instructions / Assembly

MIGWELD 250 MP

Pulse MIG

1. Push the <Welding Process> button to choose the <PMIG> process.

2. Push the <2T/4T> button to choose hold type of 2T or 4T.

3. Push the <Dia. Wire> button to choose the welding wire size.

4. Push the <Base Material> button to choose the welding material.

3. Push the <Process Selection> button to select the welding process, check the

panel<Process Indication>, the available setting will be lighted on by pushing the

Left or Right selection button.

4. Use <Encoder 1> & <Encoder 2> to adjust the welding parameters.

5. Push <Gas Check> button to check the gas before start welding.

<Encoder1> used to adjust the Current (A) showed at <DISP.1>

<Encoder2> used to adjust the Volts (V), Time (S) showed at <DISP.2>