Users Manual
Skeet Sequence Mode (T4300A-V Only)
The T4300A-V has the Skeet Sequence preloaded. This is designed for solo shooters to go out without
a trapper for practice.
To activate Skeet Sequence ModeSUHVVDQGKROGWKHDoubles EXWWRQIRUVHFRQGVXQWLOWKHGreen
Tx LED blinks rapidly. Be aware that while holding the Doubles EXWWRQWKHGreen Tx LED will begin to
blink after 4 seconds when it enters Lock On Mode. Continue to hold down the Doubles button until
it blinks rapidly.
The T4300A-V is now in Skeet Sequence Mode:KHQ\RXDUHUHDG\FDOO³3XOO´LQDQRUPDOWRQHRI
YRLFHWR¿UHDKLJKKRXVH7KHVHFRQGFDOOZLOOUHOHDVHDORZKRXVHDQGWKHWKLUGFDOOZLOOUHOHDVHD
double. The T4300A-V is now ready for stand 2. Continue through the stands and the T4300A-V will
ODXQFKWKHDSSURSULDWHWUDSVLQWKHVHTXHQFH
$WDQ\WLPHGXULQJWKHURXQG\RXPD\SUHVVDQ\RIWKHEXWWRQVWRWKURZWKHoption bird. After the
option birdLVWKURZQWKHXQLWZLOOUHVXPHWKHVNHHWVHTXHQFH
The T4300A-V will end the sequence after launching the low bird on Station 8. To throw a low 8 option
press the Low House EXWWRQDQGFDOO³SXOO´
7RH[ LWSkeet Sequence ModeDWDQ\WLPHSUHVVDQGKROGWKHDoubles button until the Green Tx LED
WXUQVRႇ
3
Link Mode (Alternative to Using Dip Switches)
1
2
3
4
Set desired Field ID Channel and Trap
Addresses on the transmitter.
Power on desired receiver with all dip switches
set to the RSHQRႇposition. The red Link LED
will blink for 15 Seconds. This indicates that
the receiver is in Link Mode. If a transmitter
has not been linked to the receiver during this
15 seconds WKH UHFHLYHU ZLOO UHYHUW WR WKH
previous settings.
The red Link Mode light on the receiver will
go solid. The transmitter and receiver are now
linked. Repeat this process to link another
receiver.
Press and hold the trap button that you would
like to assign to the receiver until the green Tx
Light RQWKHWUDQVPLWWHUÀDVKHV
Link Mode DOORZVXVHUVWRZLUHOHVVOLQNUHFHLYHUVWRVSHFL¿FWUDSEXWWRQV%HVXUHWKDWWKHUHFHLYHU
you wish to link to is in Link Mode,I\RXDUHXVLQJWKH7$9PDNHVXUHWKDWWKHUHLVQR
microphone attached to the device.
Link LED
Will blink for 15
seconds
6HWWRRSHQRႇ
position
Indicates power
is on
Dip Switches
Power LED
T4300A Field ID Must
Be Set (Channel 1
Shown Here)
R-4300 Dip Switches
Set to Link Mode (All in
WKHRSHQRႇSRVLWLRQ





