T4300A T4300A-V T4300 Skeet Long Range LLC. LC.
Introduction The T4300A and T4300A-V are simple to use transmitters that can control 2 trap machines with the push of a button. The T4300A-V has the added ability to launch targets using voice control. Both transmitters require a 9-volt battery and an antennae. Microphone Jack Only on the T4300A-V Red Power LED Trap 1 Button Antenna Green Tx Light Indicates transmitter is armed Trap 2 Button Doubles Button Throws a True Pair 3UHVV DQ\ EXWWRQ WR SRZHU RQ WKH WUDQVPLWWHU %H DZDUH WKH WKLV ¿UVW EXWWRQ SU
Button Operation (T4300A & T4300A-V) Press Trap 1 or Trap 2 WR ¿UH WKH FRUUHVSRQGLQJ WUDS 7KH Green TX LED will illuminate to indicate that D VLJQDO LV EHLQJ WUDQVPLWWHG DQG WKH FRUUHVSRQGLQJ WUDS ZLOO ¿UH 3UHVV WKH Doubles Button WR ¿UH D 7UXH 3DLU ZKLFK ZLOO ¿UH ERWK WUDSV VLPXOWDQHRXVO\ Voice Operation (T4300A-V Only) Be sure to have the supplied microphone plugged into the Microphone Jack on the top of the T4300A-V DQG FOLSSHG WR WKH ODSHO RI YHVW RU VKLUW DERXW LQFKHV IURP \RXU PRXWK 7KH 7
Skeet Sequence Mode (T4300A-V Only) The T4300A-V has the Skeet Sequence preloaded. This is designed for solo shooters to go out without a trapper for practice. To activate Skeet Sequence Mode SUHVV DQG KROG WKH Doubles EXWWRQ IRU VHFRQGV XQWLO WKH Green Tx LED blinks rapidly. Be aware that while holding the Doubles EXWWRQ WKH Green Tx LED will begin to blink after 4 seconds when it enters Lock On Mode. Continue to hold down the Doubles button until it blinks rapidly.
Trouble Shooting Frequently Asked Questions Questions Answers What should I do if my T4300A isn’t turning on? What should I do if my T4300A isn’t working? Be sure that the T4300A has a fresh 9-volt battery. )LUVW HQVXUH WKDW \RXU 7 $ LV VHW WR WKH VDPH Channel DV WKH WUDS WKDW \RX DUH WU\LQJ WR ¿UH 6HFRQG HQVXUH WKDW \RXU 7 $ LV VHW WR WKH correct Message Length. Please refer to the Dip Switches Manual included with your device. Contact Please call us with any questions.
