User's Manual

Mounting Your System:

Four captive nuts are located in a slider on the backside of the T9601 transmitter. These are used to

ecure the mounting brackets to the unit. The brackets may be mounted in several configurations de-

pendent upon the mounting surface.

1. Position the non-foam padded mounting bracket so that the side with the two holes (laying flat on

the slider) are pointing towards the antenna end of the transmitter.

2. Align the holes with two of the captive nuts.

3. Insert the 2 screws into the holes. Do not fully tighten screws.

4. Repeat steps 1-3 with the foam-padded mounting bracket. The two holes should be pointing op-

posite the antenna end of the transmitter (foam padding should be facing the opposite bracket).

Long Range Systems 5 T9601 User Manual

Captive Nuts

Mounting Bracket

Screws