User's Manual

3. Highlight the Vibe selection then PRESS and HOLD the Select Button until the screen shows.
4. Press or hold the Select Button until the desired vibration level is selected
5. If holding down on the Select Button, the vibe level will increase to max and then decrease to-
wards the minimum
6. Release the Select Button when desired vibration level has been reached
7. To exit, wait 8 seconds and the pager will go back to the vibe/contrast menu
Contrast
To set the Contrast Level
1. Remove the pager from the charger
2. While vibrating or beeping, press and hold the Select Button for 5-8 seconds
3. Highlight the Contrast selection then PRESS and HOLD the Select Button until the screen shows.
4. Press or hold the Select Button until the desired contrast is selected
5. If holding down on the Select Button, the contrast level will increase to Max (NOTE: screen could
be dark and hard to read)
6. Release the Select Button and press or hold again to change the level back towards the minimum
or until your desired contrast is selected
7. To exit, wait 8 seconds and the pager will go back to the vibe/contrast menu
8. To exit this menu wait 8 additional seconds
Settings
To view the current pager settings
1. Remove pager from the charger or reset on the T9601 reset terminals.
2. Press the Select Button repeatedly to scroll through the settings:
C1: [System ID number] and Pager ID number
C2: [System ID number] and All Page number
C3: [System ID number] and System ID number
G: Group number
Enc: Encryption enabled (128) or none
Ver: Current Firmware Version
3. To exit, wait 8 seconds.
VIBE CONTRAST
CONTRAST:
VIBE CONTRAST
VIBE
Long Range Systems 23 T9601 User Manual