User's Manual

T7400A Dry Contact Specifications:
T7400A Dry Contact Cable Specifications:
Set Alarms
This function is used to set the transmitter to page an individual or all STAFF pagers at a specific time or on
a timed interval. The transmitter can send 10 different time alarms or periodic alarms. Alarms may be set to
page a specific pager (or all pagers) at a specific time every day.
Note: Alarm feature not available in version 7.5.0.8
1. Press SETUP and enter Password.
2. Press 1 (System).
3. Press F2 (DN) until display shows 3) ALARMS.
4. Select 3 (3: ALARMS).
5. From the Alarm menu, select the number of the alarm to set (0 through 9) and press ENTER.
6. The Alarm Display screen shows the status of the selected alarm. Select Change (F1) to en-
able/disable or modify the alarm.
Note: If the alarm is already enabled as an interval alarm:
• Press F1 (YES) to reset the timer and return to the paging menu.
• Press F4 (NO) to continue to the ON/OFF menu.
7. At Enable menu select F1 (YES) to enable the alarm or F4 (NO) to disable the alarm.
8. Select the type of alarm 1 (Interval), 2 (Daily), or 3 (Weekly).
I
nput Voltage
Contact Diameter
Contact Type
0
-5 Volts DC
2.5 mm
Mono Plug
Contact Diameter
Contact Type
Number of Conductors
Ring Connection
Tip Connection
2.5 mm
Mono Plug
2
Positive
Ground
Long Range Systems 12 T7400A User Manual