User's Manual

Long Range Systems 10 T7400A User Manual

Interval

The Interval defines how many seconds of time pass between each Tracking re-page.

The Interval can be set from 10-255 seconds.

he default Interval is 10 seconds.

Example:

If tracking is enabled for a duration of 90 seconds with an interval of 10 seconds, then a tracking page will be

sent out every 10 seconds for 1 ½ minutes. So the recipient pager will go off once on the initial page and 9

more times within the next 1½ minutes. After the 1½ minute duration has expired that pager number is

removed from the transmitter queue.

To set the Interval

1. Press SETUP and enter Password.

2. Press 1) system.

3. Press F2 (DOWN) until display shows 17) Tracking.

4. Press 3.

5. Select 3) Interval.

6. Type in a new time, in seconds, and press ENTER.

Group Paging

General Purpose

This function is used with Alpha pagers. These pagers can be programmed to respond to group calls. Ten

groups are available and each pager can be a member of 5 groups. Each pager will respond to its individ-

ual number and to any groups it belongs to. See example below.

Group Paging Rules

General rules for paging groups are:

• Pagers must be programmed in the group mode.

• Staff pagers must be numbered above 100. (1-99 are reserved for groups)

• Any alphanumeric pager can be a member of up to 5 groups.

Paging Groups

1. Enter the number for the pager or the group.

• If only paging staff pagers and have the transmitter default set to Pager, enter the pager or group

number directly.

GROUP 1 GROUP 2

Pager