User's Manual

Long Range Systems 8 Table Genie UHF User Manual
Table/Room No.
This field is used to uniquely identify the Table Genie Unit being programmed. This is a free form field and
can be alpha, numeric, or alpha-numeric characters. The name given to the Table Genie is part of the mes-
sage sent to the pager when a page is sent allowing the person responding to the page know where the
p
age originated from.
Manager Pager No.
When the re-page feature is enabled (see Global Configuration) the pager number entered into the manager
pager field will be notified if a page request is not cleared within the designated three re-page intervals.
Mode
There are three different types of modes that can be set on the Table Genie. The definition of each of these
modes is as follows:
1 Button: When pressed, each of the three buttons will send the same page. Only one pager number
or one group number can be alerted with only one message in this mode.
2 Button: Only the outside two buttons can be programmed to send a page when pressed. In this
mode, the middle button is inactive. Only two pager numbers or group numbers can be
alerted with their respective messages in this mode.
3 Button: All three buttons can be programmed to send a page. Three different pager numbers or
group numbers can be alerted with their respective messages in this mode.
Left, Center, and Right Buttons
Each button can be programmed to send a different message to a different pager or group. To configure
each button, type in the message and pager or group number that each button is supposed to alert when
pressed.
Saving a Configured Table
Once you have finished configuring the table, press the save button and the table will be saved to the table
configuration tab. You are then free to create the next table as needed.