User's Manual

Group Page Enable
Enabling this feature will allow pagers that have been previously programmed into groups to be called by
their group number simultaneously. Enabling this feature will not allow you to page any individual pager
numbers that have been programmed below number 100.
To program a Table Genie to page groups:
• Enable group paging on the ‘Global Configuration’ tab.
•
When creating a new table (see programming Table Genies in the next section).
• On the ‘Table Configuration’ tab, enter the group number into the pager number field that a par-
ticular Table Genie or button on a Table Genie is supposed to page when a button is pressed.
Table Configuration
The table configuration tab allows for the individual programming of each Table Genie unit used with your
system. The individual pager or group numbers that are to respond to a button press as well as the message
that each pager receives when a particular button is pressed are configured in this tab.
To begin configuring your tables, click on ‘New Table’. Once you click on new table, you will see the config-
uration fields shown below:
Long Range Systems 7 Table Genie UHF User Manual