User's Manual

USING THE PROGRAMMING SOFTWARE
Global Configuration
T
he Global Configuration Settings are settings that will be programmed into all Table Genie units once the
specific table information is uploaded to them. These settings should be configured before creating any ta-
bles under the Table Configuration tab.
System Id
In order to prevent other LRS paging systems in the area from conflicting with your LRS paging system, your
pagers and Table Genies may be on a system ID other than the default of zero. To determine if the system ID
on your programming software should be set to something other than zero, look on the right hand side of
the packing slip included with your order for the field marked ‘System ID’.
If you do not have your packing slip for reference, contact LRS Customer Support at 1-800-437-4996 for fur-
ther instruction.
Repage Enable
Marking the repage enable field will cause the Table Genies to repage the pager up to three times. The Table
Genie will only repage if the request has not been cleared within the time you specify as the repage interval.
Cancel Acknowledge
When the repage field is enabled, you will have the option for your Table Genies to send out a cancel ac-
knowledgement page. With this feature enabled, a page will be sent to the corresponding pagers when the
page has been cleared and assistance is no longer needed.
In the example screen shown on the next page,, the repage function has been enabled at 120 second inter-
vals and will send a ‘Late Table xx’ message to the manager pager designated for this particular unit (man-
ager pager assignment is covered in the table configuration section) after the third re-page interval has
expired. If a page is cleared at the table unit at any point, the Table Genie will send a “Table Cleared xx” mes-
sage.
Long Range Systems 5 Table Genie UHF User Manual