User's Manual

USER MANUAL | RX-CS6, RX-CS7, & RX-AT9
LRSUS.COM | 4
TROUBLESHOOTING
Pager Does Not Receive Pages
1. Be sure that the pagers are charged.
2. Be sure transmitter power is plugged in and display is lit.
• If display is blank, check power supply as described below.
• If display is lit, check transmitter functions described below.
3. Pagers will flash and may or may not vibrate depending on a preprogrammed configu-
ration when removed from the charger base.
Check The Power Supply
1. Be sure the wall outlet that the power supply is plugged into is working (plug another
device into it and see that it works properly).
2. Be sure the wire that plugs into the side of the transmitter is plugged in securely.
3. Try plugging the power supply that is powering the charger into the transmitter.
• If the transmitter powers up from a known good power supply, but not from the
charger power supply, you probably have a bad charger power supply. Call Long Range
Systems for a replacement or repair.
Charging Check
Please take note of the following charging requirements and functions.
1. A maximum of 15 pagers may be stacked on one charging base at a time.
2. If your system has more than 15 pagers and you only have one charging base, call
Long Range Systems to purchase additional.
3. If your system has 2 or more charging bases, check that the jumper wires between the
bases are connected securely.
4. Pagers on charge will flash a red LED light every 5 seconds, forming an upward moving
red light on the pager stack.
5. A maximum of 4 charging bases per power supply are allowed.
6. Check for dirty charging pins on your coasters. To clean, use a damp rag, and wipe the
4 metal contacts on the front and back of each pager.
7. Be sure that all pagers are plugged in and charging when not in use. Even for long
periods of inactivity.