User's Manual
USER MANUAL | RX-CS6, RX-CS7, & RX-AT9
LRSUS.COM | 3
GENERAL INFORMATION
The guest pagers are used in conjunction with the LRS transmitters. The coasters are
used as an on-premise paging system to increase eciency by alerting customers who
are waiting, usually for services or goods.
SETUP AND USE
The low profile devices are rechargeable, water resistant, and can flash, vibrate, beep or
any combination thereof when called by an LRS transmitter. To begin using your pagers,
locate the charging base near a power outlet and charge them for 16 hours.
Charger Installation
Install the charger base per the directions received with the charger kits.
Operation
1. When a guest arrives, remove a pager from the charging stack. Pagers will light up and
or vibrate for 2 seconds.
2. Record the pager number and hand to your guest.
3. Page the pager by entering the number into the transmitter.
4. LRS guest pagers will flash, vibrate and or beep depending on the page mode sent by
the transmitter.
5. Transmitters can also send predefined time limits for each of the pager alert modes.
See transmitter manual for details.
PRODUCT SPECIFICATIONS
Required Voltage: 110-120V outlet for pager chargers, LRS issued 12VAC, 4A power
supply included in kit
Battery Type: Nickel Metal Hydride (NiMH). Rechargeable.
Battery Life: Approximately 3-5 years
Battery Charge Life: Approximately 24 hours (depends on how often they are paged).
Recharge time: 16 hours minimum from completely discharged.
Operating Range: Up to 1/4 mile
Dimensions: 4.25” x 4.25” x .75”