User's Manual

Transmitter Unit

Transmitter Display does not light when a key is pressed

• The proper power supply for this transmitter is 12VDC 4.0A

• Ensuring that the proper power supply is in use, plug the TX-9561EZ into that

power supply and allow it to charge for 30 minutes

• If the unit still is blank and has no power, substitute the power supply being used

with the power supply used for the pager charging base (this is meant as a test

only and not as a permanent replacement)

• If substituting with another power supply results in a TX-9561EZ that is working

properly, please call LRS to purchase a new power supply.

Transmitter display is okay, but the pager does not receive the page

Check whether this affects all pagers or just one pager

If only one pager is affected:

• Ensure that the pager is properly charged and initiates a vibrate/flash se-quence

when removed from the charging base

• If the pager does not vibrate and flash when removed from the charging base,

please charge it overnight before troubleshooting further

• If the pager initiates the vibrate/flash sequence when removed from the charging

base, please continue with the next steps

If ALL pagers are affected and none of them will page:

• Check the Restaurant ID on the TX-9561EZ to ensure that it matches the Restau-

Charging:

Place rechargeable pagers on the charger and let them charge for 8 hours prior to first use.

Rechargeable pagers should be kept on charge even during extremely long periods of inactivity.

Should you have any questions, please contact the LRS Customer Service Department at

800.437.4996.

TROUBLESHOOTING