User's Manual

The TX-9561EZ can program any LRS Pager type. The transmitter’s current mode of operation
must match the desired pager type to program. (Example: To program an SP4, the transmitter
must be set to the SP4 Staff Mode.)
To program an SP4, coaster, or paddle pager:
1. Remove the pager from the charging base
2. Allow the pager to complete the vibration and flashing sequence
3. Press PROG then a number from 1-799 and press Enter
(Example: For Pager #200, press PROG-2-0-0-Enter)
4. The red LED in the top right corner of the transmitter will light up once
5. The pager will glow once cycle to indicate it received the programming
To program and Alpha Pager:
1. Remove the battery from the pager
2. Re-insert the battery into the pager
3. On the keypad, press a number from 1-799 then press Prog Prog.
(Example: For Pager #200, press 2-0-0-Prog-Prog)
4. The red LED on the top right corner of the transmitter will light up three times.
5. The pager will beep three times to indicate it received programming.
PAGER MODES AND PAGER MESSAGES
5