User's Manual

The TX-9561EZ uses a preset message and paging mode when paging or sending a message to a
pager.
To change the message, press PROG-8-x-x-ENTER (with x x being the message slot from 00 to
10)
Note: This command only applies to Alphanumeric Pagers
The Alphanumeric Staff message can be edited and changed to a user defined set of messages.
(Please refer to LRS Programmer instructions for changing messages.)
The pager vibration/beep mode can be changed based on the following selections:
Example: To change POCSAG Pagers to Vibe Twice, press PROG-9-5-2-
Enter. 9-5-0 - No vibration message.
Alphanumeric (POCSAG) PAGER
The TX-9561EZ will page single pagers numbered from 1-799.
To page a pager from 1-20, simply press the pager number on the keypad.
Example: To page pager #12, press 12.
To page a pager number from 21 to 799, press the PGR button, followed by the pager number.
Example: To page pager #22, press PGR-2-2-Enter, or PGR-2-2 (this will send page, but with a
delay)
To use the All Page, press PGR-9-1-1.
This will immediately send a page to all pagers.
PAGING YOUR PAGER
PAGING MODES AND PAGER MESSAGES
3
To turn on Alphanumeric (POCSAG) Sta, press PROG-9-9-7-Enter
To turn on SP4 Sta, press PROG-9-9-9-Enter