User's Manual

rant ID for the pagers (please call LRS if you do not have this information on file)
• If the Restaurant ID is correct, all pagers are appropriately charged yet none of the
pagers page, please contact LRS
Pager(s) not charging
When placed in the charging base, do all pagers have a single red charge light lit up?
If no pagers have a charge light, this may be an issue with the power supply (please contact
LRS)
If only some pagers have a charge light that is lit, please do the following:
• Remove the main power supply and all jumper wires (all pagers will go off t once
and this is ok)
• Insert the power supply into each individual row (or base for Coasters) to see if the
pagers on that row/Coaster base all light up
• If all pagers on that row or Coaster base light up, please test the next row/base
with the power supply until you have tested each one
• If some of the pagers do not light up but those specific agers light up on other
rows/bases, please call LRS to have this row/base replaced
If all pagers have the charge light lit up as you test the individual rows/bases, you may
have a jumper wire that is not connecting properly or causing a short. Please contact LRS
to purchase additional jumper wires to replace ones that are not working as they should.
Note Regarding Pagers: Please be sure that all pagers are plugged in and charging when not in
use. Please also note that a maximum of 30 Coasters or 25 Pagers can be on one 10V power sup-
ply. If you are exceeding any of these limits, it may have long term eects on your pagers’ ability
to charge prop-erly. Please contact LRS to purchase additional charging bases to supplement
your entire inventory.
9