User's Manual

Guest Message
The Guest Message is the default canned message sent to Guest Alpha Pagers. To change the message.
1. Press SETUP and enter Password.
2. Press 1 for 1) System.
3. Press F2 (DN) until 1)POCSAG-> is displayed.
4. Press 1 for 1)POCSAG->.
5. Press 3 for 3) Guest Message.
6. Type a number 00-99 for selected canned message and press ENTER.
Note: See pg. 16 for Creating Alphanumeric Messages.
Display the Guest and Staff Prompt
When paging Guest or Staff Alpha Pagers, the user is shown a prompt:
Connect Transmitter screen Display
SELECT PAGE MODE
MSG: 035    
OUT: TABLE READY
To Enable or Disable Seeing This Prompt While Paging:
1. Press SETUP and enter Password.
2. Press 1 (System).
3. Press F2 (DN) until screen shows 1 (POCSAG).
4. Press 1 (POCSAG).
5. Press F2 (DN) until screen show 1 (Msg Editing).
6. Press 1.
7. Press 1 to select Guest or Staff.
8. Press 3) Auto send.
9. Press F1 (Yes) or F4 (No).
If Display Prompt is disabled, the message sent will default to the Guest or Staff Message.
Long Range Systems 22 LRS Connect Transmitter User Manual