User's Manual

Set Alarms

This function is used to set the transmitter to page an individual or all STAFF pagers at a specific time or on

a timed interval. The transmitter can send 10 different time alarms or periodic alarms. Alarms may be set

to page a specific pager (or all pagers) or cell phone at a specific time every day. To make an alarm contact

the manager’s cell phone, this function requires Network Enabled, cell phone paging ON, a manager cell

phone number mapped, and a valid account.

1. Press SETUP and enter Password.

2. Press 1 (System).

3. Press F2 (DN) until display shows 3) ALARMS.

4. Select 3 (3: ALARMS).

5. From the Alarm menu, select the number of the alarm to set (0 through 9) and press ENTER.

6. The Alarm Display screen shows the status of the selected alarm. Select Change (F1) to enable/

disable or modify the alarm.

Note: If the alarm is already enabled as an interval alarm:

• Press F1 (YES) to reset the timer and return to the paging menu.

• Press F4 (NO) to continue to the ON/OFF menu.

7. At Enable menu select F1 (YES) to enable the alarm or F4 (NO) to disable the alarm.

8. Select the type of alarm 1 (Interval), 2 (Daily), or 3 (Weekly).

Interval Alarms are alarms that re-page a staff pager at regular intervals.

1. Enter the desired time interval in hours and minutes (HH:MM) and Press ENTER.

2. Enter pager number to be alerted.

3. Type in canned message (See Table on pg. 8) and press ENTER.

Daily Alarms are alarms that re-page a staff pager at a particular time every day.

1. At the Time of Day menu enter the time for alarm.

2. Select F1 (AM) or F2 (PM).

3. Type in pager number to be alerted and press ENTER.

4. Type in canned message (See Table on pg. 8) and press ENTER.

Weekly Alarms are alarms that will page a staff page on a certain day of the week.

1. Select the Day of Week to page. Use F2 (DN) to scroll through Wednesday through Saturday.

2. Enter the Time of Day (HH:MM) for the alarm.

3. Press F1 (AM) and F2 (PM).

4. Type pager number to page and press ENTER.

5. Type in canned message (See Table on pg. 8) and press ENTER.

6. At Set pager Number menu, either:

• Enter the number of the pager to be alarmed followed by ENTER.

• Press F1 (KEEP) to use the existing number.

Note: Entering pager number 911 will page all Alpha pagers.

Long Range Systems 16 LRS Connect Transmitter User Manual