User's Manual

POSITIONING AND INSTALLING THE REPEATER
Note: The best place to mount your repeater is on a ceiling or wall that is very high. The idea is to get the signal
as high as possible so it “umbrellas” the guest and thus all pagers can receive it.
The repeater operates at its best when installed at the “fringe” of your area. This means you should get it as far
from the transmitter as possible but still be able to receive the transmitter’s signal.
1. Locate a 110V outlet near the selected installation location.
2. Plug the power adapter into the outlet and into the power connector hole on the side of the repeater.
3. Ensure that when power is plugged in, the Red RECEIVE light will blink continuously to indicate power is on
and the unit is operating.
4. Place the paging transmitter in “Range Test Mode” (see transmitter’s operating instructions).
 5.EnsuretheRedTRANSMITlightperiodicallyalternateashesonaboutevery5seconds.
  •IftheperiodicTRANSMITashdoesnotoccur,movetherepeaterclosertothetransmitterandtryagain.
  •KeepmovingtherepeatertowardthetransmitteruntiltheTRANSMITashoccurs.
• After establishing the correct distance, mount the repeater as high as possible.
Transmitter
Repeater
Extended Range
Normal Range
6