Owners manual

With the braided stainless steel Cable Housing, slide the Ferrule
down the Housing past the cut line before cutting the Housing.
Cut Line
Rear End
Ferrule slid past the cut line
Inner Wire removed
before cutting the
housing
Page 3
Step 8: Hook the Ford Explorer clevis onto the parking brake lever
that was supplied with your rear brake kit.
Step 9: Make sure the Emergency Brake is in the fully off position. If
you are using either a Lokar Floor Mount Emergency Hand
Brake or a Lokar Trans Mount Emergency Hand Brake,
discard the clevis that came with the Hand Brake. Connect
the brake cable clevis assembly to the Hand Brake using the
5/16" clevis pin, flat washer, and cotter pin. If you are using
a Lokar Connector Cable, remove the tension adjuster and
clevis from the cable union block, and install the 5/16"-28
threaded rod with jam nuts (not included) from the Connector
Cable Kit into the cable union block.
Step 10: Loosen the set screws in the cable union block, and insert
the inner wires into the cable union block. Using a pair of
pliers, pull on each of the inner wires until there is no slack
left in the inner wire. Tighten the set screws in the cable
union block while each inner wire is being held with no
slack.
Step 11: The Cables should be adjusted evenly. Adjust the cable
tension at the tension adjuster so that there is no slack,
but making sure that the brakes are not applied when the
Emergency Brake is released. Use the cable adjusters to
fine tune the individual Cable adjustment. Generally, you
will want the Cables adjusted so that three clicks of the
Emergency Brake will prevent the vehicle from moving
(although your braking system may be different).
Step 12: Once the Cables are properly adjusted, cut off the excess
inner wires. It is recommended that you leave approximately
one inch of extra inner wire extending beyond the cable
union block to allow for future adjustments.
See Figs. 8, 9, 10, and 11 for completed installations.
Fig. 5
Fig. 6
Fig. 7 Fig. 8
Shifter
Mounting
Bracket
Ford Explorer/Internal Wilwood Emergency Brake Cable Installation Instructions
Ford Explorer Clevis
Inner Wire
Brake Cable Ball
INS0011 Rev. 08/22/2017
Side View of Left Side:
Cable Adjuster
Bracket
Front
Front
Trans Mount
Hand Brake Only,
Top View:
Hand Brake
Assembly
(not included)
1/4" Spacer
3/8" Spacers
3/8" Spacer3/4" Spacer (not included,
part of Hand Brake Kit)