User guide

INS0080Rev.11/12/13
Page5
©2013Lokar,Inc.
Step 14:Installarodendontoeachendofthethreadedrod.Attachthethreadedrodassemblyto
the inside of the trans gear lever and to the outsideofthequadleverusingthe1/4"-28x1"
buttonheadbolts,flatwashers,andnylocknutsasshowninFig. 9 and Fig. 10. The button
headboltscanbeinstalledfromeitherdirection,butmakesuretheflatwasherisinstalled
betweentherodendandtheboltheadornut.
Step 15:Checktheadjustmentoftheshifterbyplacingtheshifterallthewayforwardinto
theParkposition.Makesurethatthereleasebuttonstillmovesupanddownfreely.
ThereleasebuttonshouldbeflushwiththeknobinParkandNeutral.IntheReverse
position,youcannotpulltheleverbackintoNeutralwithoutdepressingtherelease
button.
 WhiletheshifterisintheParkposition,makesurethetransmissionisfirmlyinthe
"Park"detent,withnotensiononthethreadedrod.Youcanverifythisbyremoving
the1/4"-28x1"buttonheadboltwithnylocknutthatattachestherodendtothe
quad lever or trans gear lever at either end of the threaded rod. Make sure the hole in
therodendexactlyalignswiththeholeinthequadleverortransgearlever.Thebolt
shouldpassfreelythroughbothholesatthesametimewithoutbinding.Donotforce
the holes to line up.
 Iftheholesarenotaligned,screwtherodendinoroutjustenoughtobeabletoslide
theboltinandoutwithoutputtingtensiononthethreadedrod.Makesurethatthe
quadleverandtransgearleverdonotmoveduringtheadjustmentprocedure.Usethis
adjustmentroutineuntiltheboltwillpassfreelyinandoutofboththerodendand
thequadleverortransgearlever.Reinstallthe1/4"-28nylocknutandtheflatwasher
in its proper position onto the bolt, and tighten.
 Onceyouhavetheshifteradjustedcorrectly,tightenthejamnutsonthethreadedrod.
Step 16: Double check to make sure that the bolts connecting the left side banana bracket to
the shifter assembly are tight. Fig. 6Removetheneutralsafetyswitch(Fig. 11) and
washerfromtherightsidebananabracketusinga7/8"wrenchorsocket.
Fig. 10 Fig. 11
Fig. 12
Trans
Gear
Lever
1/4"-28 x 1"
Button Head Bolt
Switch Plate
Switch Plate
Neutral Safety
Switch and Washer
Center Groove
in Shifter Body
Rod
End
Flat
Washer
NOTE: Bolt Can Be Installed
From Either Side, Make Sure Flat
Washer Goes Between Rod End
and Bolt or Nut
Threaded
Rod
1/4"-28
Jam Nut
1/4"-28
Nylock Nut
Right Side
Banana
Bracket
5/16"-24 x 3/8"
Button Head Bolts