Owners manual

INS0144 Rev. 12/01/2016

Page 2

Lokar Shifter Boots and Boot Rings Installation Instructions

Fig. 5

Fig. 6

Bottom edge

of Shifter Boot

turned inside out

Step 4: Decide how high you want the top of the Shifter Boot to be

on your shifter lever (all except High Top models). Lokar

Shifter Boots are designed to fit a wide range of shifter

lengths, and are intended to be cut-to-fit.

Step 5: Install the Boot Ring over the shifter lever and Shifter Boot.

Turn up the bottom edge of the Shifter Boot, stretching and

flipping the bottom edge inside out so it wraps around the

outside edge of the Boot Ring. Fig. 5 Get the Boot Ring

positioned correctly against the top of the tunnel, and the top

of the Shifter Boot at your desired height on the shifter lever.

Step 6: At this point, you may:

- Install the provided #8 x 1" boot ring screws through the

Boot Ring and Shifter Boot and into the tunnel, or

- (Recommended) Remove the Boot Ring, and apply spray

adhesive or contact cement to the underside of the Boot

Ring. Then, reinstall the Boot Ring onto the Shifter Boot,

and install the provided #8 x 1" boot ring screws through the

Boot Ring, the Shifter Boot, and into the tunnel.

Step 7: Using a sharp knife, trim off the excess boot material from

around the Boot Ring.

Install the shifter knob following the instructions provided

with the knob.

See Fig. 6 for examples of completed installations.