Owners manual

Building American Quality… With A Lifetime Warranty!
Several styles of Shifter Boots and Boot Rings are available.
General Installation Notes:
Please read these instructions completely before beginning the
installation. If you have any questions please call.
Before beginning the installation, disconnect the negative battery
cable and use wheel chocks to block the vehicle's wheels.
Refer to Fig. 1 for the component names.
Step 1: In order to begin installation of the Shifter Boot and Boot
Ring, any existing shifter boot and ring should be removed
first. The shifter lever should be installed onto the Shifter.
The jam nut and shifter knob should not be installed on
the shifter lever at this time.
Decide where you want the Boot Ring to be positioned on
the transmission tunnel. Temporarily place the Boot Ring
on the tunnel, and make sure that the position of the Boot
Ring will not interfere with the full range of movement of
the shifter lever.
Step 2: Mark the locations of the screw holes in the Boot Ring onto
your transmission tunnel. Remove the Boot Ring, center
punch the marks, and drill the holes using a 1/8" drill bit.
Step 3: Install the Shifter Boot onto the shifter lever. On a
rectangular Shifter Boot, make sure the seams in the
Shifter Boot line up with the corners of the Boot Ring. Note
that the Shifter Boot has long and short sides, just like the
Boot Ring. Fig. 2 On a round Shifter Boot, make sure the
seams are oriented where you want them.
High Top Shifter Boots Only: The threaded bezel at
the top of the Shifter Boot also serves as the jam nut for
your shifter knob. Thread the bezel all the way down to
the bottom of the threads on the shifter lever. Install your
shifter knob and adjust it as described in the shifter knob
installation instructions. Then, thread the bezel back up the
shifter lever and tighten the bezel against the bottom of the
shifter knob. Fig. 3
Classic Shifter Boots Only: There is a foam seal inside
the bezel at the top of the Shifter Boot. Make sure the
shifter lever passes through the hole in the center of the
foam seal. Fig. 4
TOLL FREE 1-877-469-7440 • [e-mail] • www.lokar.com
®
Lokar Shifter Boots and Boot Rings
Installation Instructions
Lokar Shifter Boots and Boot Rings
Installation Instructions
INS0144 Rev. 12/01/2016
Page 1
© 2013 Lokar, Inc.
Shifter Boot
Boot Ring
Short
Side
Long
Side
#8 x 1" Boot
Ring Screws
High Top Shifter
Boot Bezel
Classic Shifter
Boot Bezel
Foam seal
inside
Shifter Lever
(not included)
Shifter Boot seam aligned with corner
Fig. 1
Fig. 4Fig. 3
Fig. 2