User's Manual

1. Remove Rubber Boot.

Slide the rubber boot off of the Key Pass.

2. Open Key Pass

Insert a small coin into the indented slot on the side of the

case. Gently pry apart the two halves of the Key Pass. You

have now exposed the interior of the Key Pass. You will

notice a circular battery retained by a battery holder.

3. Remove Old Battery

Push the battery out of its holder using a non-metal tool.

Notice the + sign on the face of the battery. Put the new bat-

tery in with the + sign facing upward. Discard the old battery.

4. Replace Battery

Insert a new battery into the battery holder. The battery

MUST be installed with the + sign facing up. Slide the battery

into the holder. The red light on the face of the Key Pass

should ﬂ ash several times immediately after properly install-

ing a battery.

5. Close the Key Pass

Reassemble the Key Pass by snapping the two halves of the

case together. Insert the Key Pass back into the rubber boot.

Make sure that the battery LED indicator is visible through

the hole in the boot.

1-888-334-8712 • www.lojack.com

MAINTENANCE