Specifications

COMBI - NATION FITTINGS
ASSEMBLY OF LOGUN COMBI - PUMP
Diagram A Shows the pump unit
ready for assembly with
all the parts including
the Allen key for putting
the base together.
Diagram B Shows the pump unit with
the base being fitted.
(Allen key supplied).
Diagram C Shows the pump unit
complete with the hose
being fitted to the
connector.
Each stage of assembly of the pump is straight
forward. If problems occur during assembly please
contact your dealer.
A
B
C
Diagram A Shows the pump with the
hose fitted, this fitting on
the end of the hose is
1/8” BSP female thread.
Diagram B Shows the pump with a
Snap - On connector fitted
(not supplied) to the end
of the hose.
Diagram C Shows the pump with the
large brass bottle adaptor
fitted with a 400cc bottle
screwed in place.
The above pictures show all the variations the LOGUN
COMBI -PUMP can offer, for example Dia A shows a
female 1/8” BSP thread which will screw straight onto
a Falcon air - rifle Dia B shows a hose with a Snap On
connector fitted, this set up with the correct Snap on will
fit just about any pneumatic air - rifle with a quick release
system - on the market today. Finally Dia C shows the
LOGUN COMBI - PUMP with a buddy bottle style
screwed in place.
A
B
C
The LOGUN COMBI - PUMP has been
manufactured to exceptionally high standards to
give the operator a wide variety of choices and
set ups when filling a pneumatic air rifle. Please
see below for the settings that can be achieved.
3
2