Specifications

Welcome to the LOGUN family. Having bought this LOGUN
product, you have become a member of a group of people,
who not only insist upon but expect nothing but the best.
Logun’s motto is
“To make the best, or to make the best better”.
This is why LOGUN has joined with AXSOR in Sweden to
launch the
LOGUN COMBI - PUMP. Please read all the
information in this manual for optimum performance from your
LOGUN COMBI - PUMP.
Assembly of the LOGUN COMBI - PUMP
Combi - nation fittings & how to use them
How to operate the LOGUN COMBI - PUMP
Trouble Shooting
THE OPERATION OF THE LOGUN COMBI - PUMP
CONGRATULATIONS
INDEX
PLEASE READ THIS BEFORE USING THE LOGUN COMBI - PUMP:
Once correct fill pressure
has been reached, stop
pumping. Release air
pressure from the pump
system via the bleed screw,
this is situated underneath
the pressure gauge and is a
brass knurled screw. The
releasing of air from the
pump will make it easier for
the female connector to be
disconnected.
Connect your female fitting
(not supplied) on the end of
the hose to the male fitting.
This is situated on the end of
the rifle. Make sure the
connection is secure.
Stage 1
NEVER:
WARNING:
Stage 4
Check the bleed screw to
make sure it is tight.
Please Note; always make sure
your feet are kept on the foot plate,
this makes for a secure base when
pumping.
Stage 2
Before pumping consult
the manufacturers operator
manual - this will give you
the correct fill pressure for
your air rifle, then start
pumping. Lift the handle
upward then the best way to
pump is to use the speed and
your body weight on the
down stroke.
Stage 3
4
1
DO NOT PUT YOUR HANDS
anywhere near the air release
hole situated at the base of
your pump when releasing air
from the pump system.
SERIOUS DAMAGE CAN BE
CAUSED IF YOU DO NOT
ADHERE TO THIS WARNING.
WARNING :
do not try to release the female
connector when under
pressure as this can cause
serious damage to either
yourself or the gun.
disassemble the pump. If it
does not function correctly,
consult the trouble shooting
section of your manual. If
symptoms still persist call your
dealer. There is a risk of
overheating when you pump
continuously for a period of 10
minutes or longer. You can
cool the system down letting it
rest for 5 minutes or longer.If
you are going to use the large
air bottles, it is mportant that
you do a maximum of 100
strokes, then release the air
pressure, this removes the
condensed water which
accumulates in the special
condensing chamber built into
the pump system. After
releasing the moisture you can
continue pumping.
ONLY:
use this high - pressure
pump to fill TESTED air bottles
and air cartridges.
“.......the LOGUN high pressure pump is a sturdy stirrup type, with an
obvious high quality build, essential to generate the pressure of 200 BAR
needed to fill a PCP air rifle. The whole operation took a lot less than 10
minutes and only the final strokes required any noticeable effort”
Tim Finley, Field Target Champion and hunting ace......
2
3
4
5