Instruction Manual

4
9
Getting Started
Your Logun S-16 requires the fitting of a telescopic sight or similar
sighting device before use. Always ensure that the mounts used are
sufficiently high enough to lift the objective bell of the scope clear of
the rifle’s barrel and action. Logun recommend Simmons scopes.
CHARGING THE BOTTLE
1) Unscrew the bottle from the main body of the rifle. If some air is left
in the bottle there will be a slight hiss of escaping air as the bottle
disconnects. This is perfectly normal.
2) Attach the stainless steel bottle
adaptor to the screw thread on the
bottle. Screw the adaptor and bottle to
the air hose of your charging
equipment.
*PLEASE NOTE: YOU MAY DAMAGE THE END OF THE
VALVE PIN IF YOU DO NOT USE THE
CORRECT ADAPTOR SUPPLIED.
3) With the adaptor securely fitted, fully charge your bottle to 200 BAR
4) It is recommended that when
charging the bottle the air flow is
restricted to a slow flow. This is to
prevent any overheating of air and
bottle. If heat is felt the reading on the
gauge will be incorrect.
5) When charging is complete, “bleed”
off the excess air from the hose using the hoses’s bleed screw. Then
unscrew the bottle from the charging adaptor.
SAFETY
To activate safety, push button above trigger to safe. When safety is
on the trigger blade is locked. This ensures that the rifle does not fire.
To release safety push button to opposite side for live. Rifle is ready
to fire.
In addition to utilising the safety cross bolt,
a loaded and cocked rifle can be made safe
by opening the cocking bolt, pulling it back,
and removing the
magazine. Then, by pulling the trigger and
pushing the bolt forward, the rifle will de-
cock.
CAUTION! When de-cocking the rifle, be aware that a pellet may still
be loaded in the breech.
If the magazine is unintentionally indexed remove the magazine from
the rifle, close the bolt, point the rifle at a target and when safe to do
so, fire the rifle. Refill the magazine and re-fit to the rifle.
When the rifle is not in use, ensure that a pellet has not been loaded
into the barrel, remove the magazine and leave the bolt closed and
un-cocked.
It is recommended that the magazine is stored separately from the
rifle to prevent unsanctioned use.
If the gun is stored for any period of time we advise the bottle to be
disconnected from the gun.
SPARE O-RINGS
Each S-16 comes with four O-rings, these should only be used when
necessary. Regular lubrication of the magazine O-ring will lengthen its
life and increase the magazines performance.
O-rings included are: 2 x Magazine O-ring
3 x Bottle Valve O-ring
1 x Probe O-ring
Safety - The Logun S-16