Instruction Manual

* Never point a gun (even a BB gun) at a person.
* Always wear shooting/safety glasses and ensure all those with you wear them too.
* Never point a gun at anything other than your target.
* Always keep your gun on “safety” until you are ready to shoot in a safe direction.
* Never load your gun until you are ready to shoot.
* Always place your backstop in a location that will be safe should the back stop fail.
* Never shoot at a hard surface, water or anything that could cause a ricochet.
* Always check to see if a gun is on “safety” and unloaded when receiving it from
another person or from storage.
* Never put a gun away loaded.
* Always be sure of your target and be certain your target has a safe back stop.
* Never re-use ammunition.
* Always ensure you use the correct calibre ammunition.
* Never rely solely on the safety catch to ensure safety.
* Always treat your gun as if it were loaded and with the appropriate level of respect
a loaded firearm demands.
* Always read and follow the manufacturers manual and instructions.
* Always make sure you understand how the gun works prior to using it.
* Always keep your finger off the trigger and outside the trigger guard until you are
ready to shoot.
* Always keep your gun in a safe place, ensuring no unauthorised person can use it.
* Always abide by national and local firearms regulations and laws.
* Always use correct greases and oils - Logun recommend only Logun Performance
Products.
* Never use silicone oil or grease.
Shooting is probably the safest sport in the world but remember that
misuse and careless use of guns can cause serious injury or death.
Ask, listen, think - if in doubt - don’t!
Rules of Safe Shooting
310
Looking After Your Logun S-16
Each Logun S-16 is built to provide a lifetime of high performance
service and requires very little in the way of user maintenance beyond
a wipe over with a synthetic oil impregnated cloth after every use.
In fact, the best way to keep your Logun operating perfectly is to do
nothing at all except send it back to Logun every year for a full
service by our trained technicians. The carrying out of this service is
a condition of the Logun S-16 Lifetime Warranty.
Your Logun S-16 is built almost exclusively from aircraft grade
aluminium and stainless steel which all but eliminates the problem of
rust suffered by many other airguns. However, a quick wipe over all
metal surfaces with a lightly synthetic oiled rag will maintain a
pristine appearance.
It is vital that the rifle is never dismantled or modifications made other
than by trained Logun technicians. Such actions will be highlighted to
our technicians through the examination of several anti-tampering
devices built into the rifle. If any such evidence manifests itself, the
rifle’s lifetime warranty is invalidated.
Lubrication
The Logun S-16 is designed to run maintenance free between annual
factory services, at which time all necessary lubrication will be
carried out. If the cocking bolt requires lubrication, use a very light
smear of thin synthetic grease on the mechanism. The appropriate
grease can be obtained from your Logun stockist.
It is recommended that the trigger mechanism of your rifle remains
as-lubricated by the Logun factory technicians.
Note:
Over-lubrication of your Logun S-16 can result in the attraction and
accumulation of dust and grit which can affect the performance of the
rifle.