Instruction Manual

2 (Published May 03)
11
Rules of Safe Shooting
Getting Started
Loading the Logun S-16
Adjusting The Trigger
Safety
Looking After Your Logun S-16
Stock / Bottle Cover Adjustment
Do’s and Don’ts / Problems
Service Record
3
4
6
7
8
9
10
11
12
CONTENTS
DO clean your rifle with a synthetic based spray - apply spray to lint
free cloth then wipe over rifle.
DON’T spray silicon spray directly onto the rifle as this could cause
problems with the greases within the action and cause the gun to jam
DON’T leave the bottle valve exposed, always replace the dust cover.
DO use a synthetic grease on the magazine O-rings and on the bottle
‘O’ ring. This will increase their lifespan and performance.
DON’T rely on the safety catch to provide guaranteed safety.
DON’T leave a pellet loaded in the rifle and remove the magazine from
the rifle when you have finished shooting.
DON’T fill the bottle too quickly. If it is charged too fast it can dislodge
the valve from its seat.
DON’T cock and fire the gun without the magazine being in place,
doing so could damage the bolt probe O-ring.
DON’T use any silicone sprays or oil or grease on the gun.
DON’T use any mineral based oils or greases.
Do’s and Don’ts
PROBLEMS
In the unlikely event of your Logun S-16 showing signs of
malfunctioning or of reduced performance, DO NOT attempt to rectify
the problem yourself. Please call the Logun Service Line where they
will either talk you through any simple rectification or arrange for the
rifle to be returned to the Service Centre for repair.
Logun Service Line - 01902 722 144