INSTRUCTION MANUAL Sole Distributor Airgunsport Ltd Universe House, Key Industrial Park, Planetary Road, Willenhall, West Midlands, WV13 3YA England TEL: 01902 722 144 Fax: 01902 722 880 e - mail: logun@advantage-holdings.co.uk www.logun.com www.airgunsport.com www.freetargets.
F E B Fast Firing Bolt Action In-Line Valving System 2 Stage Trigger Shaped Rubbers Grip Buddy Bottle Power Plant Shaped Shoulder Plate Pressure Gauge Scope Rail KEY A B C D E F G H G I J K L M N O P A D I C M N H L O J P Scope (Optional Extra) Note: Logun recommend Simmons scopes Forend Logun Silencer Mag Release Button 16 Shot Drop Magazine Logun Smart Lamp (Optional Extra) Logun Bipod (Optional Extra) Crosman Laser (Optional Extra) K
SERVICE RECORD Your rifle must be serviced bi-annually by an approved Logun Service Centre. Failure to do so will invalidate the rifle’s lifetime warranty. Service Due Date Date Serviced Serviced By: Service Centre Stamp LOGUN S-16 INSTRUCTION MANUAL MODEL: S-16 SERIAL No:................................... FILL PRESSURE: 200 BAR 12 CALIBRE:.......................................
Do’s and Don’ts CONTENTS DO clean your rifle with a synthetic based spray - apply spray to lint free cloth then wipe over rifle.
Rules of Safe Shooting Looking After Your Logun S-16 * Never point a gun (even a BB gun) at a person. * Always wear shooting/safety glasses and ensure all those with you wear them too. Each Logun S-16 is built to provide a lifetime of high performance service and requires very little in the way of user maintenance beyond a wipe over with a synthetic oil impregnated cloth after every use.
Safety - The Logun S-16 Getting Started SAFETY Your Logun S-16 requires the fitting of a telescopic sight or similar sighting device before use. Always ensure that the mounts used are sufficiently high enough to lift the objective bell of the scope clear of the rifle’s barrel and action. Logun recommend Simmons scopes. CHARGING THE BOTTLE 1) Unscrew the bottle from the main body of the rifle. If some air is left in the bottle there will be a slight hiss of escaping air as the bottle disconnects.
Getting Started Fitting a Laser Using a 2.5mm allen key loosen the two allen bolts at the front end of the synthetic forend. Push the plastic plug out of the aperture by applying pressure from underneath via the thumb aperture. Push the laser into the aperture, it may be a tight fit and secure in place by replacing the allen bolts. Zero the laser, using the 3 small screws at the front of the laser, with the zero of your scope.
Loading The Logun S-16 continued Having filled one half of the magazine, invert and fill the second half. Once the magazine has been fully loaded refit it to the rifle by sliding back into the magazine chamber until it clicks. Adjusting The Trigger Make sure the rifle is unloaded by removing the magazine and ensure there are no pellets in the breech. Remove the air bottle and apply the safety cross-bolt. Invert the rifle and secure in a rifle stand or similar stabilising device.
