Instruction Manual

ADJUSTING THE TRIGGER

To adjust the first trigger stage, adjust screw (7).

To adjust the second trigger stage, the safety must be OFF and the rifle

un-cocked - then adjust screw (13).

NOTE: When you have altered the position of the trigger block, adjust the

screw (3) for the safety function. To do this, release nut (4) and adjust

screw (3) until it gets as close to the trigger block as possible without

touching it. Lock the screw and nut after adjustment.

NOTE: Always ensure the rifle is not loaded before proceeding with any

alterations to the trigger. If the position of the trigger block (9) is changed

with screw (13), ensure a sufficient amount of sear engagement with the

hammer is maintained. After adjustments have been made, please ensure

that the safety mechanism functions normally.

NEVER attempt to remove the trigger mechanism from the rifle!

NOTE: Any trigger screw adjustments will require re- Loctiting

to prevent

self adjustment. Use a thread locking agent such as Loctite 242

1. Safety Handle

12. Adjuster Screw

13. Adjuster Screw

11. Trigger

9. Trigger Block

8. Spring

7. Adjuster Screw

6. Adjuster Screw

5. Spring

4. Lock Nut

3. Adjuster Screw

2. Backpart

10. Trigger Housing

SAFETY

To activate safety, rotate backpart (2) to the

right with safety handle (1). When safety is

on, the trigger block is locked by the backpart

and the trigger housing (10) is locked by

screw (3). This ensures that the rifle doesn’t

fire. To release the safety, rotate the back

part to the left.

Please note: The safety will only operate correctly when the rifle is

in the cocked and ready to fire position.

FIRE

SAFE