Instruction Manual

SECTION 5

ADJUSTING THE TRIGGER

Before it leaves the factory, each Logun MkII will have its trigger adjusted

to a safe and efficient setting. Different shooters prefer different trigger

set-ups and your Logun MkII offers an almost unlimited range of set-up

options. However, you are advised to alter the setting of your rifle’s

trigger only if you really need to. Please familiarise yourself with the rifle

before deciding on your preferred trigger setting because it’s entirely

possible that the factory setting will suit you perfectly.

Should this not be the case and you wish to re-set your rifle’s trigger,

please refer to the photograph below and follow all instructions carefully.

NOTE: FIRST CHECK THAT THE RIFLE IS UNLOADED AND THAT

ITS PELLET MAGAZINE IS EMPTY. Trigger adjustment requires the

removal of the stock. This is done by unscrewing the hex-headed, single

stock fixing bolt (A), located on the underside of the fore-end just ahead

of the trigger guard. There is no need to remove the trigger guard, simply

separate the action from the stock after removal of the stock fixing bolt.

Remember to store the stock fixing bolt carefully

(A)