Use and Care Manual
Step 2: Drilling Holes
Drilling curtain rod bracket holes
Drill holes for the bracket screws: Use a 3/32-inch drill bit if the screws will
be installed in wall studs; use a ΒΌ-inch drill bit if the screws will be installed
into drywall. If you are installing the screws in drywall, you should use
plastic anchors.
Once you have drilled the hole in the drywall, insert the plastic anchors all
the way into the hole. The screws will then screw into the plastic anchors.
Step 3: Install the Brackets
Installing curtain brackets
Screw in the mounting brackets: Align the screw holes on the mounting
brackets with the holes you drilled in the wall. Use a standard screwdriver
and screw in the bracket screws.
Before you tighten the screws completely, check and make sure that the rod
fits correctly into the brackets; then tighten.
Step 4:Hang the curtain rod
Step 5: Install Your Fabric Panels