BC05 Flash BT Module PRODUCT SPECIFICATION PROJECT Bluetooth Module CUSTOMER Logitech REVISION V1.
TABLE OF CONTENTS LIST OF TABLES…………………………………………………………………………………………………….…....3 LIST OF FIGURES………………………….……………………………………………………………………………..3 1. Revision History ……………………………………………………………..……………………………….……..3 2. Product Description and Specification………….………………………………………………….……….…...4 2.1 Product Description……….. ……………………………………………………………………......................4 2.2 References………………………………………….…………………………………………………..……….…4 3. Hardware Description………………..................................................................
LIST OF TABLES Table 1: Revision History ………………………………………………………………………………….……...3 Table 2: General Specification ……………………………………………………………………………..........4 Table 3: BT Pin Description …………………………………………………………………………….……......7 LIST OF FIGURES Figure 1: BC05 Block Diagram………………………………………………………………………….……......5 Figure 2: Bluetooth Module Block Diagram ....…………………………………………………………………5 Figure 3: BT Pin Configuration and Mechanical Dimension …………………………………………….
2. Product description and specification This product is a Cost-effective single-chip stereo solution. Module used CSR BlueTunes Flash BGA BC57H687C chipset. 2.1 References BlueCore5-Multimedia External CS-121064-DSP2 General Features Fully Qualified Bluetooth v2.1 + EDR Specification System Best-in-class Bluetooth Radio with 8dBm Transmit Power and -90dBm Receive Sensitivity 64MIPS Kalimba DSP Co-processor 16-bit Internal Stereo CODEC 95dB SNR for DAC Low-power 1.5V Operation, 1.8V to 3.
3. Hardware Description 3.
3.
3.3 BT Pin Description Pin No. Name 1 2 3 4 5 VDD ENC0 GND ENC1 6 7 SCL PCM_IN Type Function POWER Output Ground OUTPUT CMOS input, with weak internal pull-down. OUTPUT 3.3V Power amplifier standby Cround connections NC I2S CHARGE MODE CONTROL PCM_OUT CMOS output, tri-state, with weak internal pull-down I2S 8 9 SDA OUTPUT CHARGE MODE CONTROL PCM_SYNC Bi-directional with weak internal pull-down.
3.
3.
3.
4.0 FCC STATEMENT Federal Communications Commission (FCC) Statement 15.21 You are cautioned that changes or modifications not expressly approved by the part responsible for compliance could void the user’s authority to operate the equipment. 15.105(b) This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
5.0 IC STATEMENT This device complies with Part 15 of the FCC Rules and Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. （French） L’appareil est conforme à la réglementation FCC, section 15 et Industrie Canada RSS standard exempts de licence (s).
