Setup guide

Logitech Mobile Speakerphone P710e
English 7
Setup with a computer
• Connect the USB cable from the P710e into
your PC.
• Ensure that the P710e is selected as the
default audio device in your OS settings and
in your application.
Setup with a Bluetooth device
• Press and hold Power button to turn ON
the device.
• Press and hold the Bluetooth button
on the side of the P710e until the blue
lights start flashing in a clockwise circle.
Place your mobile device in pairing mode
and pair to the P710e. You may pair up to
eight Bluetooth devices with only two active
at the same time.
• If you have an NFC enabled device, position
it near the NFC target area on the P710e.
You should see a message on your phone
asking if you would like to pair to the P710e.
– P710e must be powered on.
– Note, position your NFC enabled device
near the NFC target area a second
time to disconnect from the P710e.
This is helpful if you’re still in range
of the P710e, but want to handle calls
on the mobile device.
– Repeat the procedure again
to reconnect.
USB