Owner's Manual

10 Logitech
®
11Transporter
™
Owner’s Guide
Confi guring Transporter
The instructions below use the remote control to set up Transporter. You can also use the front
panel controls. To scroll up and down, turn the knob on the front panel. Pressing the center of
the knob is equivalent to pressing the
RIGHT arrow on the remote. Pressing the BACK button
on the front panel is the same as pressing the
LEFT arrow. The other buttons on the front
panel are the same as the corresponding buttons on the remote.
When you plug in Transporter, the Slim Devices logo is displayed briefl y, followed by
a welcome message.
Set Up Networking
1. Press the RIGHT arrow on the remote control. The Set Up Networking menu option
is displayed.
2. Press the
RIGHT arrow to enter networking setup.
3. Choose whether you want to connect Transporter to a wireless or wired network
by pressing the
UP and DOWN arrows on the remote. When you have made your
selection, press the
RIGHT arrow. If you are using an ethernet connection, skip to step
7.
4. Transporter prompts you for your local region or country. Scroll using the DOWN
arrow on the remote until you fi nd the local region. Press the
RIGHT arrow to select
your region.
Note: Failure to select the appropriate region may violate local laws.
5. Transporter will scan to fi nd your wireless network. Select your network name (SSID)
and press the
RIGHT arrow.
If you are in an area where there are multiple wireless networks, you can scroll
down using the remote until you fi nd the one you want to use. If your router is not
broadcasting your network name, you will need to select “Enter a network name”.
Tip: You can use the number buttons on the remote to enter text as you might
on a
cell phone. Use the PLAY button on the remote as a backspace and the ADD
button to insert a letter.
6. If your network is secured with WEP or WPA encryption, you’ll need to enter the
network password or key using the numbers and letters on the remote and press
the
RIGHT arrow. If your network supports more than one type of encryption
at a time or is not broadcasting its SSID, Transporter may fi rst ask you to choose
your encryption method.
Tip: WEP keys consist of a string of ten or twenty-six digits or letters A through F.
WPA
passwords are a string of letters, numbers or punctuation.
Enter the subnet mask for the network, the default gateway IP address, and the
address of your DNS server, pressing the
RIGHT arrow on the remote to move to each
one.
Tip: If you are having trouble connecting to your wireless network, check the
Frequently Asked Questions section at the end of this guide.
Select a Music Source
1. If SlimServer isn’t already running, start it now.
Transporter will scan your local network to fi nd the computer that’s running
SlimServer. If you started SlimServer after confi guring Transporter, you may need to
scroll to fi nd it.
Tip: If SlimServer is running on your computer and you don’t see it in this menu,
check the Troubleshooting section at the end of this guide and make sure that any
fi rewall software you have installed is confi gured properly.
You can also choose to connect to the SqueezeNetwork internet service.
See the SqueezeNetwork section of this guide for more information.
2. Select the computer you want to use. If you are running SlimServer on multiple
computers on your local network, you can use the
DOWN arrow to scroll to the one
you want to use.
3. Press the
RIGHT arrow on the remote to connect.
Setup is complete.
Tip: If you want to go back to setup later press the LEFT arrow on the remote
down
and hold it for fi ve seconds. Transporter will return to the Set Up
Networking menu.