Operation Manual







• Make sure that AudioStation™ is on.
• Make sure that the iPod input is selected.
• Make sure that the volume level on AudioStation™ is at least half way up. Use the volume buttons on
AudioStation™ to adjust.
• Use the iPod Updater (available at apple.com) to upgrade your iPod to the latest iPod rmware. Early
rmware versions on some iPods prevented music from playing through the dock connector.

• If you have a newer iPod, a Universal Dock adapter for your iPod should have been included with your iPod
when you purchased it.
• If you have a 1st, 2nd, or 3rd generation iPod, you need to use the Aux input connector on the back of
AudioStation™. To do so, you will need to purchase a separate cable to connect your iPod to the Aux input.
(1st / 2nd generation iPods do not have a dock connector. 3rd generation iPods are not supported by the
AudioStation™’s Universal Dock.)

• Use the external AM antenna.
• Make sure to disconnect the wires for the internal AM antenna before connecting the external antenna.

• Use the external FM antenna.
• Make sure that the antenna is fully extended. Leaving the antenna coiled up will result in poor reception.

1. Point the remote directly at AudioStation™.
2. Make sure the remote sensor isn’t being blocked. (It is located just above the Logitech logo.)
3. Try using a fresh set of batteries.

1. Turn AudioStation™ on.
2. Press ‘menu’ on the remote several times — until ‘Brightness (on)’ appears.
3. Use to adjust the brightness level while AudioStation™ is on.
4. Press ‘menu’ again. ‘Brightness (off)’ appears.
5. Use to adjust the brightness level while AudioStation™ is off.


Performance
• Power: 80W RMS
• Max SPL: 110 dB at 1m
• Frequency Response: 36 Hz to 23 kHz. (+/- 3 dB)
Bi-amplied transducer design using:
• (2) 1” ventilated soft-dome tweeters
• (2) 4” reinforced long-throw polypropylene woofers
• Sealed, tuned speaker enclosures
• Removable speaker grilles
Electronic design
• Tweeter amplifiers: (2) ultra-linear Class AB
• Woofer amplifiers: (2) High-efficiency, Class D
• Digital electronic crossover
• DSP-controlled, dynamic, digital EQ and filtering
• Adjustable sound field (bass, treble, 3D stereo)
Connections
• 3.5mm aux input jack (for MP3 players and 1st/2nd/3rd generation iPods)
•
Universal Dock (for 4th generation (and newer) iPods, including iPod mini,
iPod nano, and iPod with video)
• Composite and S-Video pass-through jacks

