Quick Start Guide

PRODUCT SETUP

1. Press the power button for 1 second. The LED will turn green —ready to go.

2. If LED turns red, charge the pen before use.

LED Behavior Logitech Crayon status

Fade in green Power on

Fade out green Power o

Solid green Fully charged

Breathing green Charging

Blinking red Battery level is critical (less than 5%)

Red when user presses button Battery level is low (less than 10%)

Green when user presses button Battery level is good

Yellow Firmware update

KNOW YOUR PRODUCT

Lightning port

Cap Power button Pen tube Tip cover

TipLED

LOGITECH CRAYON

Setup guide

Make sure iPad iOS is updated

to version 11.4 or above

PAGE 1
LOGITECH CRAYON Setup guide KNOW YOUR PRODUCT Cap Lightning port Power button Pen tube Tip cover LED Tip PRODUCT SETUP Make sure iPad iOS is updated to version 11.4 or above 1. Press the power button for 1 second. The LED will turn green — ready to go. 2. If LED turns red, charge the pen before use.
PAGE 2
CHARGING 1. Flip open the cap. 2. Insert lightning cable. 3. Connect cable to a power adapter or any computer to charge. 4. LED will turn green. REPLACING THE TIP COVER 2 1 Find the removal tool. 4 3 Align the tool with the two holes in the pen tube. 5 Make sure tip is tightened before replacing tip cover. Insert new tip cover into pen until you hear a click. Squeeze the tool and pull off the tip cover.
PAGE 3
REPLACING THE TIP 2 1 Find the removal tool. 4 3 Align the tool with the two holes in the pen tube. 5 Twist the tip counter-clockwise to remove. Squeeze the tool and pull off the tip cover. 6 Insert new tip and twist clockwise to tighten securely. Insert new tip cover into pen until you hear a click. REPLACING THE CAP 2 1 Open the cap. 4 Push the cap ring into position, making sure the notch fits into slot. 3 Push the cap back and slowly pull the cap ring off of the pen tube.