User's Manual

3 Testing your remote after you have set up your RF System

Your remote will walk you through steps to test your system after you have set

up your RF System.

If your Blasters aren’t placed properly or you have not assigned your devices

correctly, your remote’s screen will walk you through steps to correct any

issues you may be having.

Test and test again

Before you being the test, make sure all of your devices are off.

If you have closed cabinet, you should also perform this test with the

doors closed.

2 Assigning your devices

You can control your devices with either your Harmony remote or your RF System.

Typically, you use the Harmony remote to control devices with which you have a clear

line-of-sight, and you use the RF System to control devices that are in a closed cabinet or

that span different rooms.

For example, you would likely use your Harmony remote to control the TV because it is

out in the open, but you would use your RF System to control the AV receiver and the

DVD player, which are tucked away inside a cabinet.

During initial set up, your remote will walk you through the steps to assign devices to

your Harmony remote or RF System.

Device Assignment

1/2 pages 7:15

Select devices you want to

be controlled by your RF

system

Cancel Done

Off

Cable