User Guide

You can then re-run FSX.
Change the X55 Rhino / X56 H.O.T.A.S. F.E.E.L. Spring
To insert, change or remove a spring, follow these steps.
NOTE: Make sure the trigger is facing away from you and that the logo plate on the device is
facing you.
1. Turn the Locking Bezel (part B) counterclockwise until the Stick comes away from the
base.
2. Remove the Seal Ring (part C) by placing finger from your left and right hand under the
ring on either side, and then lift up. The Seal Ring it stiff by design
3. Pry apart the Locking Clamps (part D). These pull apart from the stick, but are under load
from the spring. Take one half off first, hold the spring, and then remove the other half.
4. Remove the Spring (part E), then either replace with a new Spring or leave the Spring off.
To reassemble, reverse the order of the above steps, making sure to securely seat the Seal Ring
(Part C) and firmly tighten the Locking Bezel (part D) on the Stick base.