Setup Guide Guide d’installation Ultrathin Touch Mouse for Mac 1
English . . . . . . . . . . . . . . . . . 4 Deutsch . . . . . . . . . . . . . . . . 16 Français . . . . . . . . . . . . . . . . 28 Italiano . . . . . . . . . . . . . . . . 40 Español . . . . . . . . . . . . . . . . 52 Português . . . . . . . . . . . . . . 64 Nederlands . . . . . . . . . . . . . . 76 Svenska . . . . . . . . . . . . . . . . 88 Dansk . . . . . . . . . . . . . . . . 100 Norsk . . . . . . . . . . . . . . . . . 112 Suomi . . . . . . . . . . . . . . . . 124 www.logitech.com/support . . .
Get to know your mouse Bluetooth connect button On/Off switch Off 1 On 2 Connect Bluetooth Easy Micro-USB Switch port Touch surface Status light 4 English Micro-USB charging cable
Set up Bluetooth On your mouse Power on Slide the power switch to the On position. Off On 1 Connect Select Bluetooth channel 2 Off On Slide the Bluetooth 1 Easy Switch to position Connect 1 or 2. 2 Press Connect The status light blinks blue rapidly to indicate the mouse is ready for pairing with a Mac. Off 1 Connect The status light blinks while the mouse is discoverable—three minutes.
Set up Bluetooth On your Mac After confirming that Bluetooth is on, go to System Preferences > Bluetooth and click to open Bluetooth Setup Assistant. When Ultrathin Touch Mouse appears in the device list, select it and click Continue. Follow the on-screen instructions. When pairing is complete, the status light on the mouse lights steadily blue for 30 seconds. Install software Experience all your mouse has to offer.
Pair with another Mac To use your mouse with another Mac, connect to it using the remaining channel. Slide the Bluetooth Easy Switch to the unused channel and press Connect. Repeat the instructions in “Set up Bluetooth”. To reconnect to one of your paired Macs, select the Bluetooth channel you used for the initial pairing. Visit Product Central While online, check out Product Central, your destination for world-class support.
Gestures Clicking (one finger) Click. Press the left side of the touch surface. Right-click. Press the right side of the touch surface. Lift the nonclicking finger completely off the surface. Scroll. Swipe one finger up, down, or sideways.
Charge the battery Use the charging cable to connect the Touch Mouse to your computer or a USB power adapter. The status light blinks green while the mouse is charging. Charge your mouse until the status light stops blinking. (A blinking red light means it’s time to recharge.) Each minute of charging gives you about an hour of use.
Troubleshooting Mouse not working? • On your Mac, confirm Bluetooth is turned on. • Slide the On/Off switch to Off, then back to On. • If the Battery Status light flashes red, recharge the battery. (See “Charge the battery.”) • Confirm that the selected Bluetooth channel (1 or 2) is the same channel you used to initially pair the mouse with your Mac. • Restart your Mac. • Check the Bluetooth settings on your Mac to see if “Ultrathin Mouse” is listed.
Support www.logitech.
www.logitech.com ©2013 Logitech. Logitech, the Logitech logo, and other Logitech marks are owned by Logitech and may be registered. All other trademarks are the property of their respective owners. Logitech assumes no responsibility for any errors that may appear in this manual. Information contained herein is subject to change without notice. 620-00XXXX.