User's Manual




LT‐D‐0211rev16

Page|52


Defaultbase‐Station:CheckthisboxtomaketheBase‐Stationthedefaultoneintheapplication,
if more than 1 is connected. Making a Base‐Station the default one will undo any previously
selectedBase‐Stations.
SerialConnection
ComPort:Selectfromthedrop‐downlisttheCom‐Porton
whichtheBase‐Stationis connected.
Connected–CheckthischeckboxtomarkthatConnectionisavalidconne ctionmethod.

 PressOKtofinishthefirststepinconnectinganewBase‐Station
6.4.2 AddingaGatelocator
FromtheConnectiontabpresstheAddbuttonlocatedatthe
ExciterSelectionsection.
Thefollowingwindowappears
:
Choosethecomportandclickonconnectiftheunitisconnectedtothecomputer.
IftheunitisnotconnectedtheunitIDwillnotbesavedontheunit.
6.4.3 DefiningaunitIDtotheGateLocator
If this
is thefirsttimeusing thisGateLocator,you might want toassign it with aunique Device‐IDfor
yoursystem:
 ConnecttheGateLocatortoyourcomputerusin gaUSBcable
 SelecttheCom‐Portfromthedrop‐downlistandpresstheConnectbutton.
 Set
theExciterIDvaluetoauniquenumberandpresstheSavebutton.
When finished the unit will be saved. In order to add the unit to the base station move to "Base
Station"tabandperformthefollowing(notethatthebasestationhastobeconnected):
1. From
the“BaseStation”dropdownlist,selecttheBase‐StationthroughwhichtheExciteris
tocommunicate(nearestinstalledBase‐Station).
2. Pressthe“AddExciter”button.Thefollowingwindowappears:
