User's Manual
Table Of Contents
- Table of Contents
- Chapter 1: Introduction
- Chapter 2: Theory of Operation
- Chapter 3: Safety
- Chapter 4: Clinical Guide
- Chapter 5: Preparing the System for Use
- Chapter 6: Operating Instructions
- Chapter 7 - Troubleshooting and Maintenance
- Handling Error Messages and Notifications
- Troubleshooting
- Initialization Error Message Appears
- System Does Not Turn On
- Inadequate or No Aiming Beam
- No Laser Energy Emission
- “Popping” or “Tapping” Coming Sound from the Fiber Port
- Fiber Burn Back
- Unrecognized Fiber
- A Notification or Error Message Appears on the Control Panel
- System Overheats
- Message Appears: Attach an Authorized Fiber
- Message Appears: Attach fiber
- Message Appears: Attach footswitch
- Message Appears: Check footswitch
- Message Appears: Check interlock
- Message Appears: Insert debris shield
- Message Appears: No lasers
- Message Appears: Energy high
- Message Appears: Energy low
- Message Appears: Rate high
- Message Appears: Rate low
- Routine Periodic Maintenance
- Hospital/Clinic Staff Maintenance
- Professional Maintenance
- Chapter 8: System Requirements and General Information
- Appendix A: EMC Guidance and Manufacturer's Declaration
Lumenis
®
Pulse
TM
50H / 100H Laser Systems Laser Safety Eyewear
UM-20006520DE, Rev. A Page 71
Laser Safety Eyewear
Refer to Laser Safety Eyewear in the Safety and Regulatory section of this
manual for detailed laser safety eyewear information.
Replacement Parts Part Numbers
Compatible Optical Fibers
The laser system is intended for use only with Lumenis-qualified optical
fibers. Contact Lumenis Customer Service for a list of available products.
Pressure
77 – 106 kPa
Max. altitude
3,050 m (10,000 ft.)
Environmental requirements (non-operating conditions)
Te m p e r a t u r e
10 to 40°C (50 to 104°F)
Humidity
30 to 75% at 30°C/86°F
Debris shield (glass and holder)
SPSA-10090190
Debris optic (glass only)
SPOP-10025270
Laser system key
5107-0146