User's Manual
Table Of Contents
- Table of Contents
- Chapter 1: Introduction
- Chapter 2: Theory of Operation
- Chapter 3: Safety
- Chapter 4: Clinical Guide
- Chapter 5: Preparing the System for Use
- Chapter 6: Operating Instructions
- Chapter 7 - Troubleshooting and Maintenance
- Handling Error Messages and Notifications
- Troubleshooting
- Initialization Error Message Appears
- System Does Not Turn On
- Inadequate or No Aiming Beam
- No Laser Energy Emission
- “Popping” or “Tapping” Coming Sound from the Fiber Port
- Fiber Burn Back
- Unrecognized Fiber
- A Notification or Error Message Appears on the Control Panel
- System Overheats
- Message Appears: Attach an Authorized Fiber
- Message Appears: Attach fiber
- Message Appears: Attach footswitch
- Message Appears: Check footswitch
- Message Appears: Check interlock
- Message Appears: Insert debris shield
- Message Appears: No lasers
- Message Appears: Energy high
- Message Appears: Energy low
- Message Appears: Rate high
- Message Appears: Rate low
- Routine Periodic Maintenance
- Hospital/Clinic Staff Maintenance
- Professional Maintenance
- Chapter 8: System Requirements and General Information
- Appendix A: EMC Guidance and Manufacturer's Declaration
Lumenis
®
Pulse
TM
50H / 100H Laser Systems Chapter 8: System Requirements and
UM-20006520DE, Rev. A Page 65
Chapter 8: System
Requirements and General
Information
Installation
The laser system is shipped directly from the factory to your site. Your
Lumenis service representative initially uncrates, inspects, sets up, and
installs the laser system to ensure that it is working properly. In addition,
Lumenis provides in-service training to ensure that your surgical staff is
experienced with the performance and safety considerations of the laser
system.
Thereafter, you or the nursing staff at your facility will perform the daily
maintenance routines associated with the laser system and any delivery
systems used during surgery.
If your scheduled surgical procedure requires disposable delivery devices
or accessories, it is helpful to have extra items ready and available in the
treatment room should they be needed to complete a procedure.
CAUTION:
For Canada, the system must be installed and operated according to CAN/
CSA-Z386-08: Laser safety in health care facilities.
Accessories
• Safety eyewear
• SlimLine SIS 200, 365, 550, 1000
• SlimLine EZ SIS 200, 365, 550
• Xpeeda D/S/L optical fiber
• SlimLine Endo SIS 200, 365, 550 optical fibers
• SlimLine GI SIS 365 optical fiber