User's Manual

Lumenis
®
Pulse
TM
50H / 100H Laser Systems “Popping” or “Tapping” Coming Sound
UM-20006520DE, Rev. A Page 53
“Popping” or “Tapping” Coming Sound from the Fiber Port
This is probably due to a malfunction of the optical fiber connector.
• Replace both the optical fiber and the debris shield.
Fiber Burn Back
Optical fiber burn back may occur during prolonged procedures,
especially when using higher power.
• Renew the optical fiber tip by stripping and cleaving the fiber.
Unrecognized Fiber
1. Replace the optical fiber with a Lumenis compatible one and resume
normal operation.
2. If problem persists, contact Lumenis Service.
A Notification or Error Message Appears on the Control Panel
There are three types of clearable errors:
• An error message that clears automatically (i.e., “Attach an
Authorized Fiber”) when an authorized fiber is attached.
• An error message that clears when the stated problem is resolved
(i.e., “High temperature” will clear when the temperature of the
system goes down).
• An error that requires user acknowledgement after resolving the
problem (i.e., “Energy High”); press the Standby button on the
screen to clear the message.