User's Manual

Lumenis
®
Pulse
TM
50H / 100H Laser Systems Post-Operative Instructions
UM-20006520DE, Rev. A Page 49
Post-Operative Instructions
1. Set the system to Standby mode.
2. Turn the keyswitch to the (off) position.
3. Disconnect the optical fiber from the laser system.
If the optical fiber is single-use, discard it. If it is multiple-use, prepare
the optical fiber for reuse as instructed in the appropriate optical fiber
instruction guide.
4. Set the laser system’s main power circuit breaker to the Off (down)
position
5. Turn off the mains circuit breaker.
6. Remove the main power plug from the wall receptacle and wrap the
power cable around the cable rack (see figure 11).
7. Remove the footswitch connector from the laser system. and hang it
from the footswitch storage mounts (see figure 11).
8. Disconnect the external door interlock.
9. Clean the exterior surfaces of the laser system.
Figure 11: Laser Console Cable Rack and Footswitch Storage Mounts
Footswitch Storage
Mounts
Cable Rack