User's Manual

Table Of Contents

Lumenis

Pulse

50H / 100H Laser Systems Treatment Screen Description

UM-20006520DE, Rev. A Page 45

Figure 9: Treatment Beam Delivery via Right or Left Pedals

6. Notification bar - errors and notifications appear in the notification

bar at the bottom of the screen, to alert you of a necessary action or a

laser malfunction. Refer to Handling Error Messages and

Notifications for a list of advisory indications, their probable causes,

and solutions.

7. Total Energy – The Total Energy display shows the total holmium

energy, in kilojoules, delivered since the last reset. The display

automatically resets to zero the first time you press Ready after

turning on the laser system, to allow reading of the total Energy of last

treatment. To manually reset the display, press the Clear kJ selector.

8. Standby/Ready mode selection – Standby/Ready buttons determine

whether pressing the footswitch will activate the laser system (Ready

mode) or not (Standby mode).

WARNING:

Except during actual treatment, the laser system must always be in

Standby mode. Maintaining the laser system in Standby mode prevents

accidental laser exposure if the footswitch is inadvertently pressed.

9. Clear kJ – clears the calculated total energy from the control panel;

should always be cleared at the beginning of a new procedure.

Fault XXX

Clear kJ

897